Flat Tip pH Electrode for Skin and Scalp with Quick Connect DIN Connector - HI14143/50

More Views

Flat Tip pH Electrode for Skin and Scalp with Quick Connect DIN Connector - HI14143/50

$190.00

The HI14143/50 is a glass body, single reference junction pH electrode made with low temperature glass and a quick connect DIN connector. This pre-amplified electrode features a built-in temperature sensor for temperature compensated measurements in a single probe design.


This electrode has a unique open junction design in which there is a viscolene (hard gel) electrolyte layer that is free of silver chloride (AgCl) between the sample to be measured and the internal reference cell. The open junction design resists clogging and the probe’s flat tip makes it ideal for pH measurements on surfaces such as skin and scalp. The HI14143/50 is recommended for use with Hanna’s HI99181 pH meter.


Open Junction


Flat Tip


Built-In Temperature Sensor

Details

Hanna Instruments offers a wide variety of pH electrodes that are designed for many different applications. The type of glass used for sensing pH, bulb shape, body material, type of junction, type of reference and electrolyte used are just some of the design considerations.

The HI14143/50 uses low temperature (LT) glass, flat tip bulb, glass body, and open junction with viscolene gel electrolyte.

Glass

Low Temperature Glass Formulation

The glass tip uses a special LT glass formulation with a lower resistance of approximately 50 megaohms compared to general purpose (GP) with a resistance of about 100 megaohms. This is beneficial since many food products are stored at low temperatures. As the temperature of the glass decreases in the sample, the resistance of the LT glass will increase approaching that of GP glass at ambient temperatures. If using GP glass, the resistance would increase above the optimum resistance for the high impedance input of a pH meter.The HI14143/50 is suitable to use with samples that measure from 0 to 50°C.

Flat Tip

Flat Glass Tip

A flat tip is recommended to optimize surface contact for surface skin and scalp measurements.

glass Body 

Glass Body

The glass body is ideal for laboratory use. The glass is resistant to many harsh chemicals and is easily cleaned. The glass body also allows for a fast transfer of heat to the internal reference electrolyte. The mV generated by the reference cell is temperature dependent. The faster the electrode reaches equilibrium, the steadier the reference potential.

 

Open Junction

Open Junction Reference

Suspended solids and proteins found in food products will clog a conventional ceramic reference junction. This clogging will impede the measurement circuit between the indicating electrode and the internal reference resulting in slower response time, erratic readings, and frequent electrode replacement. The open junction design consists of a solid gel interface (viscolene) between the sample and internal Ag/AgCl reference. This interface not only prevents silver from entering the sample, but also makes it impermeable to clogging, resulting in a fast response and stable readings.

DIN connector

 DIN Connector

The HI14143/50 uses a quick connect DIN connector. This type of connector is made for Hanna meters that accept a quick connect DIN connector. The HI14143/50 is recommended for the HI99181 pH meter. Other type of connectors include BNC, screw type, T-type, and 3.5mm to name a few.

Reference Cell Type single, Ag/AgCl
Junction Type/Flow Rate open
Type of Electrolyte viscolene
Body Material glass
Glass Type low temperature (LT)
Tip / Shape flat
Matching Pin no
Max. Pressure 0.1 bar
Optimum pH Range pH: 0 to 12
Temperature Operating Range 0 to 50°C (32 to 122°F)
Body Length/Overall Length 50 mm / 93.5 mm
Temperature Sensor yes
Outer Diameter 12 mm
Cable 7-pole; 1 m (3.3')
Connector Type quick connect DIN connector
Amplifier yes
Recommended Use skin, scalp, and surface measurements

Customers also purchased:

Reviews: